[PO JAN 2025] Kawada D3F735 C-CAR FRONT TIRE HI-RUBBER 35deg
Easy to handle with weak undercut characteristics!! Introducing the new HI rubber front tire!!
This is a front tire for Tamiya C-cars.
HI rubber compound is recommended when it is difficult to secure rear grip on outdoor low-grip surfaces.
The surface has been polished and R-treated, so it is easy to use and can be driven as is with just glue.
●Outer diameter: Approximately 62mm ●Inner diameter: Approximately 44mm ●Width: Approximately 30mm
*Since HI rubber has little wear, the outer diameter is set 2mm smaller than the conventional L rubber and C rubber to consider the front-rear balance.
[PO JAN 2025] Kawada TT30735 SHEET TIRE W30 HI-RUBBER 35deg
Easy to handle with weak undercut characteristics!! Introducing the new HI rubber front tire!!
A cost-effective sheet-type sponge tire that can be cut and pasted to make a "ring".
"I want to keep tire costs down" "It hurts to suddenly cut it down to a small diameter" Sheet tires are the ultimate eco-tires that meet such needs!!
Not only can they be used as practice tires, but they are also of high quality enough to be used as racing tires. (The material is the same as regular donut tires)
Recommended for front tires when it is difficult to secure rear grip on outdoor low-grip surfaces!!
[Size]
30 (width) x 730 (length) x 4 (thickness) mm
*HI rubber is shorter in length than conventional L rubber and C rubber due to differences in the dimensions of the original material.
[Suitable]
●Front tire for 1/12 EPR
●Front tire for World GT
●Front tire for F1 (F103 series wide)
●Front tire for C-car
*Makes about 6 tires for 1/12 or F1 (wheel diameter φ36~38mm).
*The length of the product depends on the length of the original roll (material dimensions), so please note that there may be some variation in the actual length.
*The listed size is the nominal size. Shrinkage may occur due to the characteristics of the material.
[PO JAN 2025] Kawada B6351 5mm Li-Po CONNECTOR for 1S
Introducing a LiPo battery connector with a Φ5mm connector!
This battery connector is useful for charging square LiPo batteries and as a conversion connector when mounted in a car.
●Φ5mm plug ●2P connector (female) ●Cord thickness: 10AWG
[PO JAN 2025] Kawada B6352 5mm Li-Po CONNECTOR for 2S
Introducing a LiPo battery connector with a Φ5mm connector!
This battery connector is useful for charging square LiPo batteries and as a conversion connector when mounted in a car.
●Φ5mm plug ●Φ2mm plug ●2P connector (female)
●JST-XH balanced connector ●Cord thickness: 10AWG
