Metal Line Nipper, Plastic Model Tool, Red

Industry first (*) compatible with metal lines 
Metal wire nippers for flat cut metal wires from 0.016 to 0.08 inches (0.042 to 2 mm). 
■ Double-edged nippers for metal wire targeted from the metal line used for model making, such as 0.08 inch (2 mm) diameter brass wire. 
It can be cut with a flat section instead of the "crushed cross sections" common with common metal wire nippers. 
With this single piece, you can use it widely for metal wire for models. 

■ Beautiful cross-section and reduced finish time 
As far as possible it is cut as flat as possible, so it will flatten and expand with almost no change in shaft diameter. 
It can also be used for cutting metal wire of various sizes, from metal line 0.02 (0.042 mm) to 0.01 inch (2 mm) diameter brass wires. 

Uses Godhand's unique blade cutting technology "Hybrid Edge". The blade is changed from the center of the blade, half the tip and half the root side. This single piece can be used with both fine wire and 0.08 inch (2 mm) wires. 
Specialized for cutting wire materials up to 0.02 inches (0.5 mm) at the tip side and 0.02 inches (0.5 mm) to 0.08 inch (2 mm) at the 
The blade is attached to the cutting surface as flat as possible on the target wire 

As of April 2020, manufacturers researched 

Quality notation 
Double-edged nippers for metal wires, with springs; Total length: Approx. 5.1 inches (130 mm); Weight: Approx. 2.3 oz (65 g). 
Soft grip, cap included. 

Cutting capacity 
Brass wire: Φ0.008 inch (0.2 mm) (tip) to 0.08 inch (2 mm) (root) 
Metal line: No. 0.02 0.042 mm ~ (tip) 
Copper wire: Φ0.008 inch (0.2 mm) (tip) - 0.08 inch (2 mm) (root) 
Aluminum wire: Φ0.008 inch (0.2 mm) (tip) to 0.08 inch (2 mm) (root) 
Stainless steel wire (non-baked on): less than 0.02 in (0.5 mm) (root) 
Never cut the stainless steel wire at the tip of the blade. 
Hardened and hardened type, stainless steel etched parts, spring materials, etc. cannot be cut. 
Piano wire is not intended for cutting 

Precautions 
Do not cut anything other than the targeted wires. 
For safety, please wear protective glasses. 
The objects may fly, so please make sure there are no people around you, or there are no fragile items before working. 
Please do not direct contact with the blade edge. 
Please do not put any load over the capacity. Pay attention to the stress on the tip. 
To prevent rusting, wipe away dirt and fingerprints, and apply oil to the shaft and edge. 
Keep out of reach of small children. 

• Nippers for metal wires targeted from metal lines to 0.08 inch (2 mm) brass wires 
• Primary in Japan 
• Specifications: Total Length: Approx. 5.1 inches (130 mm), Weight: Approx. 2.5 oz (65 g), Double-edged nippers for metal wires 
• Compatible Materials: Brass wire, metal line, copper wire, aluminum wire 
• Do not cut anything other than the intended wire material