Ko Propo 40455 VFS-FR2 (Limited Black Edition) ESC

 

■Limited version with specially designed heat sink Equipped with a special heat sink designed for limited products. This is a limited item that can only be obtained here, so don't miss it! *There are no differences from the regular version other than the heat sink in the main unit specifications, presets, etc.

■Set contents that are safe for beginners! Easy to install as is after buying it. It has a built-in preset program that suits any car. In addition, you can easily connect it to the motor with a connector, so you can rest assured. After that, you can run it immediately by following the initial settings in the manual.

■Equipped with LiPo cut function! Lithium polymer batteries will break if they are over-discharged, but the VFS-FR2 has LiPo cut mode as standard, so you can play without worrying about over-discharge. You can use Ni-CD, Ni-MH, and Li-Fe batteries even in LiPo mode.

■Powerful BEC circuit for peace of mind when using 2 servos! Equipped with a 6v3A BEC circuit (receiver/servo power circuit). The BEC circuit of the VFS-FR2 uses expensive large-capacity elements, not parallel connection of 1.5A elements as seen in overseas products, and will not be damaged even if two high-current servos are used for 4WS. The limiter function is designed to activate in the event of trouble such as steering lock, so you can use it with confidence.

■Suitable for experienced drivers! At first, you will want to drive faster with the motor that comes as standard with the kit, but as you gain experience, you will want to drive faster. Since the VFS-FR2 has an unlimited number of motor turns, you can change the drive frequency to maximize the high-spec motor characteristics when you want to demonstrate even greater performance.

[Features]

●Normal evolution of the VFS-FR ESC with reverse, which has been well received for its ease of use.

●Equipped with forward, brake, and reverse functions.

●BEC output 6V 3A.

●Equipped with a VFS function that can be set to 64 frequencies from 500Hz to 5.3kHz for each of the 32 positions on the forward side, allowing you to change the throttle feeling to your liking.

●Recommended settings that are compatible with any car are installed at the time of shipment. The recommended settings allow you to use up to the following number of turns. If you are using a motor with even higher power output, please adjust the parameters. LiPo: 12T or higher recommended LiFe, NiMH: 23T or higher recommended

●Back cancel possible when setting up the ESC alone.

●Equipped with heat protector.

●Equipped with LiPo cut (at the time of shipment. Can be changed to NI battery with ICS function)

●Please use "VFS-FR Manager Ver 1.20" as the setting software.

 

[Please note]
※Since the number of configurable parameters has increased, the conventional setting card cannot be used.
※A PC and ICS USB adapter HS are required to change the cut voltage and each parameter setting.
Set contents

Main unit x 1 (silicon cord already installed)
Heat sink x 1 (installed on the main unit)
Nameplate sticker x 1