Sanwa/Airtronics 101A31506A
101A31506A MT-4S Drift Transmitter Receiver Set F2500/ERS-971/RX-381
MT-4S
The response of double response ※ MT-4 ratio of surprise on the heels of M12!
By 2, CODE AUX function, 3 gain adjustment of SGS-01C, the LCD backlight will be added and various settings of the corresponding ※ SUPER VORTEX ZERO SSL can be adjusted to correspond to the device from the prop (Sanwa Synchronized Link) function,
I realize the usability even better
The set includes
■ system / 2.4GHz spread spectrum method computer system ■ Applications / RC general ■ CH number / 4ch
■ transmitter / TX-432 ■ Receiver / RX-381 (FH3 3ch)
Special equipment
● White LED backlight ● large full dot LCD monitor ● ● telemetry function menu selector (multi-selector operation)
● ST, TH tension adjuster fully adjustable trigger ● ● ● body built-in antenna channel set ● ● dual-rate end point adjustment ● anti-lock brake function ● curve (exponential / adjustable rate control)
● servo speed ● ● offset trim / sub trim ● servo reverse
● (the same function as the. MX-3X select the type of operation 3ch) AUX1
● (the same function as the. MX-3X select the operation type of 4ch) AUX2
● fail-safe function (radio / battery)
● timer (lap / interval / down)
● wrap ● ● logger memory function model (model 18)
● Model name (10 characters)
● Model (select / clear / copy)
● ● Direct Model Select trim type (center / parallel)
● throttle type (70:30 / 50:50)
● RF MODE set (FH4T/FH4FT/FH3/FH3F/DS2)
● Response mode setting (NOR / SHR / SSR) ※ CAUTION ● key assign (SW / TRIM / DIAL / LEVER)
● AUX TYPE setting ? CODE AUX (name change function)
Step AUX (step 1-100)
Point AUX (2 ~ 6 points)
? 4WS mixing (FRONT / REAR / NORMAL (in-phase) / REVERSE (reverse phase))
? MOA mixing (front-wheel drive / four-wheel drive / rear wheel drive) ※ drive ratio variable ? AUX mixing (ST mixing, TH mixing)
● Buzzer (Scale and volume change)
● transmitter battery alarm ● LCD contrast ● ● Boryumua just mechanical steering angle adjustment ● wide grip pad included ● 4 cell battery specifications ● compatible receiver: RX-371, RX-442DS, RX-381, RX-451, RX- 451R, RX-461, RX-462, RX-471, RX-472
Notes - Supplementary Information
For details on the response of the telemetry system
● It is said that the introduction of telemetry system in general, the response is to decline, but the technical staff of SANWA has been resolved in the algorithm and data processing into its own common sense.
In other words, it has become without any degradation in response, the system of the best unbeatable.
● It is possible telemetry system can be used safely in the race, and immediately analyze the valuable information obtained in the race, to take advantage of the running and setting of the next race.
With regard to the response mode
● Please note that analog servo does not work SHR, the SSR mode.
If you use the analog servo SHR, in SSR mode by mistake, servo. Doing so does not operate normally, please do not use the analog servo SHR, in SSR mode absolutely.
Both NOR, of SHR mode will also work if (SRG series, Digital ERG series, SDX series) of digital servo.
●, 01, HV-12 STOCK SPECIAL SRG series servo, SUPER VORTEX ZERO, HV will operate in response mode of all SSR, SHR, the NOR.
● BL-RACER, BL-FORCE, BL-psort, F2000, F2200, F3000 SHR, in SSR mode,
F3300, SBL-01, SBL-02, SBL-03CR does not work. Please use the NOR mode always.
● SV-08, HV-10, HV-12, F2500 will work NOR, in SHR mode.
RX-381 Receiver
●Sanwa High Response (SHR) support
●2.4GHz FHSS3 Spread spectrum system 3ch
Frequency 2.4GHz FHSS3
Channel 3ch
Nominal Input Voltage 4.8～7.4Ｖ
Dimensions 37.5ｘ24.7ｘ14.1mm
Weight 8.0g
Compatible radio M11X, EXZES X, MT-4, MX-3X, GEMINI X
Notice
Dimensions on product specification only shows the size of receiver itself and it excludes length of the antenna and crystal projection.
To maintain the reception of device, please do not cut the antenna. For additional information, please read official manual for each product.
ERS-971 Low Profile Servo
● Low profile digital servo for car ● WATERPROOF (equivalent to IPX4)
● Equipped with aluminum heat sink specification ● Bearing coreless motor adopt double bearings
Speed 0.09sec/60 ? (6.0V)
Torque 9.2kg ? cm (6.0V)
Dimension 40.8x20.2x25.5mm
Weight 44.5g
F2500 ESC
● high response mode (SHR) support ● Battery select function deployment ● Low battery function deployment ● heat protect function deployment ● corresponding motor: 12 turn or more ● forward + brake + back ● Back Cancel function deployment
Working voltage???
Ni-cd/Ni-MH 7.2V
Li-po 7.4V
Continuous maximum current???
88A (forward) 44A (backward)
Loss resistance???
0.0004Ω (forward) 0.0008Ω (reverse)
Size???
35.1x29.1x22.0mm
Total weight???
46g
[Note]
When you set up the battery select, please set Turn ON the power of the transmitter.
